NOTE: This form is used to collect required data at the request of an
HP Support Engineer for an open support call.  Do NOT use it to open a 
new call.  If you need to open a new call, please see the information 
at http://www.hp.com/go/hpprocurve and select "technical support", then 
"warranty information and assistance".

        HP Procurve Series 4200vl Switches - Required Data

             Product Number: ___4204vl (J8770A)  
                             ___4208vl (J8773A)  
                             ___4202vl-48G (J8771A)
      			     ___4202vl-72 (J8772A)
				     ___4208vl-64G (J8774A)
				     ___4208vl-96 (J8775A)  


Firmware revision: _____________________
 
ROM version: ___________________________ 
To get Firmware and ROM versions from the Series 4200vl switches, use 
the "show system" or "show flash" CLI commands.  


Precise problem statement: __________________________________________

_____________________________________________________________________

_____________________________________________________________________

_____________________________________________________________________

What symptoms lead you to believe that the switch is not operating 
correctly? __________________________________________________________

_____________________________________________________________________

_____________________________________________________________________

Total number of switches affected? __________________________________

Did the problem begin at installation? ______________________________

How long has the switch been in operation? __________________________

What changes were made to the switch configuration prior to the 
problem episode? ____________________________________________________

_____________________________________________________________________

What changes were made to the network topology/conditions prior to the 
problem episode? ____________________________________________________

_____________________________________________________________________

How often does the problem occur? ___________________________________

What is the current workaround, if any? _____________________________

_____________________________________________________________________

What troubleshooting steps have you performed to isolate the problem
to this switch? _____________________________________________________

_____________________________________________________________________

_____________________________________________________________________

__________________________________________________________________
If you have network management (e.g. ProCurve Manager) that can 
monitor the device, what is the network management product and what 
pertinent information does it report?  _____________________________________________________________________

_____________________________________________________________________

_____________________________________________________________________


Please attach the following information:

1. Network topology map: 
   a) All IP addresses and subnet masks of devices that are relevant 
      to the problem.
   b) Port mapping of connected network devices.
   c) Port mapping of connected clients/servers relevant to the 
      problem.

2. TECHNICAL SUPPORT DATA:  This output will help HP gather valuable
   information about your switch. The data should be captured while
   the problem is occurring.  

   i) From a console connection or TELNET session, use the following 
      CLI command: 

          show tech all [*ENTER*]

      and capture/log the output; or

   ii) You will need a TFTP server.  Use the following CLI command:

       copy command 'show tech all' tftp <TFTP server's IP addr> <filename> [*ENTER*]

3. CRASH LOG:  You will need a TFTP server to get this binary file. Use the 
   following CLI command:  (Slots A-D only if 4204vl) 
      (Hint: You may want to use [UP ARROW] to recall previous commands.)

           copy crash-log master tftp <TFTP server's IP addr> <filename> [*ENTER*]
           copy crash-log a tftp <TFTP server's IP addr> <filename> [*ENTER*]
           copy crash-log b tftp <TFTP server's IP addr> <filename> [*ENTER*]
           copy crash-log c tftp <TFTP server's IP addr> <filename> [*ENTER*]
           copy crash-log d tftp <TFTP server's IP addr> <filename> [*ENTER*]
           copy crash-log e tftp <TFTP server's IP addr> <filename> [*ENTER*]
           copy crash-log f tftp <TFTP server's IP addr> <filename> [*ENTER*]
           copy crash-log g tftp <TFTP server's IP addr> <filename> [*ENTER*]
           copy crash-log h tftp <TFTP server's IP addr> <filename> [*ENTER*]


Call ID ___________________________________________________

HP Support Engineer name __________________________________

Customer Name _____________________________________________

Customer's Company Name ___________________________________

Customer Phone # __________________ Fax # _________________

Customer Email Address ____________________________________


Reminder: Include attachments 1-3 from above!!!

                                                             November 2006